Combustion Pump Replacement (WI-phx42-107)

Click here for a printable version of this procedure.

Items Needed

Reference Procedures

WI-phx42-111 Removing/Replacing the Enclosure Lid

Procedures

Reminder: Before you replace a pump, confirm there is no contamination in the probe / sample delivery system. The contamination which ruined the last pump, could ruin the new pump if not removed. Contamination will always require an RMA.

1. Report an Issue. Failure to do so voids the warranty.

2. Wait to be instructed by LDARtools Support to change the pump.

3. Remove the phx42 enclosure lid.

4. Put the phx42 into “Sleep Mode” or power it down.

5. Remove the Viton tubing from the combustion pump.

6. Cut the center of the Teflon tubing to remove the pump (1 clear tubing on the combustion pump).

7. Gently follow the wire to the connector.

8. Unplug the connector, pulling from both sides of the connector (not the wire).

9. Remove the pump from the mounting clip.

10. Remove the remaining Teflon tubing from the push-to-connect fitting.

11. Insert the new pump’s Teflon tubing through the pump clamp opening to the tubing’s midway point.

12. Press and hold on the pump clamp for 3-5 seconds, then release and remove the tubing.

13. Insert the new pump into the push-to-connect fitting.

14. Plug in the electrical connection.

15. Reattach the Viton tubing to the combustion pump.

16. Replace the enclosure lid.

17. Run a self-check.

18. To close the reported issue, log into the LDARtools Customer Portal, and enter the new pump serial number in the hardware issue under the “Close Issue with SN” tab and select “Start Sample Pump Warranty.” This will activate the warranty on the pump. Failure to do this will void the warranty.