The following reports are available in the “Emissions” folder on the Reports tab.
Report | Description |
---|---|
Emissions by Chemical |
To generate accurate results, this report requires two key elements:
The report pulls data from the emissions calculation selected in the “Select Existing Emissions Data” section**. It uses the emissions for each component, identifies the associated stream, and allocates emissions to individual chemicals based on their percentage in the stream. Finally, it totals the emissions by chemical and presents the results, broken down by LUnit. **If you do not have any records in the “Select Existing Emissions Data” section, use the “Generate New Emissions Data” button to perform a calculation. If you do not have an Emission Model in the dropdown, see the Emissions Calculations article for information on how to set one up. |
E3 Emissions by LUnit | Calculated emissions for each LUnit, the specific emissions for each component in the LUnit are shown. |
Emissions by Single Component | Shows the details of how the emissions for any specific component is calculated. Use for when diagnosing an emission from the Emissions By LUnit that you don’t understand. |