Skip to main content

Handling Misidentified Leaks

Published: 2023-03-24      Revised: 2026-11-03

If a technician mistakenly assigns a leak to the wrong component (e.g., the leak is assigned to the valve, but later determined the leak was coming from the valve end flange), then you can follow this process:

  1. Ensure "Component MisIdentified" is included in the Leak Close Why picklist.

  2. Open the Leak grid and select the misidentified leak.

  3. Close the leak with the Leak Close Why = Component MisIdentified.

  4. Ensure you enter an inspection on the leaking component so you can properly manage the leak.

  5. If you want to backdate the inspection to the date when the original leak was found, you will notice the leak created is automatically managed from that original date. This means you might have missed the first 5-day repair deadline.

    Let's hope that didn't happen. If it did, you can always make a comment on the leak.

  6. If you want to, you can then delete the initial misidentified inspection.

Closing the leak as Component MisIdentified also undoes the original inspection's credit: the inspection requirement it satisfied is no longer satisfied, so the original component is due again. Redo the inspection on it. To do this, open the Component grid, locate and select the component, and put it in a Tour. Then monitor it.

What Chateau Does to the Monitoring Schedule​

Opening a leak drops the component's monitoring phase immediately. Closing it as Component MisIdentified reverses that:

Two conditions decide whether you see the phase change:

  • If the component has another open leak, the phase stays at M1.
  • If the component was already at M1 when the leak opened, there is nothing to restore.

The restored phase appears on the Component grid as soon as the leak is closed.